Applicable Substrate：

Suitable for porous absorbent , strong, smooth, dry, clean , no cracks , no grease, no wax floors ;

Applies to the hard cement-based self-leveling screed ;

For aerial wood flooring , plywood and particleboard cushion .

Primary Treatment:

Subfloor if oil, water and mold release wax , wax water decontamination required treatment ; minor sand from the ground suggested M318 aqueous primer ( porous absorbent subfloor ) bottoming closed ; does not recommend the use of flat subfloor MSYH self-leveling for leveling ( leveling thickness of at least 2m ); wet subfloor moisture treatment recommended by two component epoxy moisture primer . The presence of cracks is recommended to use two-component epoxy material subfloor repair.

Technical Parameters：

Milky: White color

PH value: 7-8

Density: 1.4kg / L

Dosage: 200-350g /m²

Wait time: About 10 minutes ( due to temperature and humidity vary )

Can load time: ≥ 24h

Final setting time: ≥ 7d

Construction Method:

Without dilution , without the need to deploy , with A2 or A3 sheet tooth scraping the glue evenly over the surface coated in construction . If the surface of the open barrel found a small amount of clear liquid , stir and then need to glue construction. According to the construction site of the temperature and humidity , wait about 10-20 minutes after ( sticky hands drawing a clear sense of touch ) can spread the glue on the surface of the floor , and then push the plate with cork flooring flatten , then 50 kg pressure roller rolling on the paved floor , can achieve better results.

Note:

If the temperature is below 15 ℃ construction or relative humidity above 75 percent , consult technical advice . After opening mortar surface as a film , you must first remove , stir before use . Do not glue dumped into drains or sewer. Seal the lid after use . Washable tools or excess glue .

Packaging and Storage :

25kg plastic pails. The product shall be kept at room 5 ℃ -35 ℃, prevent freezing, exposure. Shelf life of 12 months.